Forum Replies Created
-
Posts
-
Yes, that’s the one. In the order form you can customize the colors of the boards. I ordered a red, blue, and orange in batches of 10 just because the cost difference was so little at that point. The iSpindel board version 4.0 is what I currently have sitting on my desk. I like Jeffery’s board as it provides a better way to adjust the battery weight to calibrate the device. I did just finally find a solution to the calibration of the 4.0 boards today. Turns out there is a wide variance in weights of the batteries even in the exact same model. The battery that I received was heavier than a previous one that I had so I swapped them around and was finally able to get it within the 24-26* angle in pure water.
I’m attempting to figure out the sites formatting for URL posting but not having much luck at the moment.
Hey Guys,
So a guy on youtube that goes by Open Source Distilling just posted his calibration video today. He mentions the same issue I have been having with the 4.0 board that I have purchased. Considering ordering the Jeffery board instead. Is anyone interested?
Dave
Hey Evan,
Sounds like I can lend a hand then. I did order my parts in bulk as ordering them in one-off was too expensive. I figured down the road I could help others get them set up and going too I’ll have to check to see what I have sitting on the shelf. Not looking to upcharge anyone on it. I just hope to help others out. I’m just finally getting around to getting my home brewery going and have a lot to learn yet myself but I’m good at the techie stuff. I’ll need to pull up my notes on what I did and what I sourced as I don’t have it handy at the moment but glad to share.
-Dave
Glad to help, I have mine setup to data log the results to a Raspberry Pi. Here is a result of one of the first batches I did with it.
Attachments:
